June 04, 2013 | AVR Programming |

Serial Communications with the ATtiny84

In a previous post, I talked about serial communications with an ATmega168. But that chip has USART - hardware support for serial communications. But what about the tinyAVRs? As continuation of my last post on setting up the ATtiny84 for programming, this time, I will talk about sending data from an ATtiny84 to a computer using serial communications.

First, I recommend that you watch this fun and informative video on serial communications by Pete from Sparkfun, USA:

So, now that we have some idea about serial communications, let's talk about implementing a transmit only (TX) for the ATtiny84. Here is our scheme:

The above image shows the transmission of a byte (with value 0x95). The value is sent one bit at a time, starting with the least significant bit (LSB), every 1/9600 seconds, thus giving us a baud rate of 9600. The data format for a packet for the 9600 baud 8-N-1 serial connection is as follows:


(In the above, the 2 idle bits at the end are not strictly necessary.)

So how do we implement sending a bit every 1/9600 seconds? For this, we use the 16-bit timer (Timer1) of the Attiny84 in CTC mode. The value for the top of the counter is calculated as shown in the image above.

In the ISR for the timer, we keep track of the current data byte and the current bit being sent, and keep setting the output pin high/low as appropriate.

Here is the code that implements the above ideas.

The Makefile is the same as we used in the ATtiny84 introduction post:

This is the schematic for wiring it up:

Here is what the breadboard setup looks like:

And here is the output from CoolTerm. It was surprisingly easy to get this working. ;-)


On OS X, you can use the screen command to see the serial output. For example:

$ screen /dev/tty.usbserial-A7006Yqh 9600


We love hearing from our readers. Email us at for questions or comments on this article. If you found this article useful, please support us by buying some of our Open Source hardware products - like ZeroDriver - an Arduino Zero compatible motor driver for robotics. ZeroDriver is crowdfunding right now. Please click here to support our campaign. and bring this product to market!

Please sign up for updates

Once in a while, we will send you an email update on the latest Electronut Labs projects and products. Your email address will never be shared or abused, ever.

2016 Electronut Labs. All rights reserved.